Body:　Domestic 1982 and up (1/24th or 1/25th scale) must be of plastic or resin. (No styrene). Body may be lowered, but must maintain two thirds of the front bumper. Body must retain original door lines. Body may not be chopped. Wheel-wells may be enlarged to reflect the pro stock look not to exceed 1-5/16” on 1/25th scale and 1-1/2” on 1/24th scale. No two seat coupes, i.e. Corvettes, Vipers, Prowlers etc.

No convertibles. (T-Tops ok). Vehicle must resemble full scale I.H.R.A. or N.H.R.A. pro stock vehicles.
Body must have original front and rear bumpers as delivered by the factory. Rear bumper/valence may be opened for wheelie bar struts. The portion of the bumper/valence panel between the wheelie bars may be removed. The removed area shall not exceed 13/16 by 3/16 inch Head lights, parking and taillights must be retained in stock original factory location but they may be filled and reproduced by decals and/or paint

Diaplanes:　Prohibited.

Hood Scoop:　Must be pro stock style scoop. All cars must have a scoop.

Rear Spoiler:　Pro stock style spoiler with spill plates only. Must be chrome or painted to match paint
scheme of car. maximum length is 7/8”measured from mounting point of body to end of spoiler. It
cannot be molded into body. Minimum length ¼”. Spoiler width must be as wide as the deck lid and
no wider than the rear fender where attached. Spoiler must attach to the tail end of rear deck no lower than horizontal. Spill plates cannot measure more than 5/16” tall.

Chassis:　Unlimited, ball bearings allowed. All motors must be mounted in-line only.
Front Wheels: ¾” minimum diameter. As measured from the outside diameter of the tire. The
angling of front wheels to allow lowering of front end prohibited. Flat spotting of tires to allow for
clearance is prohibited. Wheelie bar length 5’’ max.

Rear Wheels/Tires:　Wheel hub diameter 5/8”, tire diameter minimum 1-1/16”. Minimum tire tread
width fully contacting track surface (0.500”).

Motor:　TSR Falcon

Weight:　120 grams